Skip to main content
0

Home Forums Ask Karen Assembly tool cap nuts?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #10320
    Tom Dunn
    Participant

    The clamping arms on my assembly tool came with cap nuts (closed at the top instead of open, as a nut would be).
    Therefore, it can only go down the clamping arm until it runs into the cap of the nut. Did i throw away the open nuts accidentally? I can go buy the nuts easy enough at Ace but what are these for?

    Think of these as panel knobs for industrial use, good ones with a brass thread seat in them and a complete closed roof.

    #95279
    Gunny743
    Participant

    I have the same issue, mine just arrived today and there were no “ nuts.”…

Viewing 2 posts - 1 through 2 (of 2 total)
  • The forum ‘Ask Karen’ is closed to new topics and replies.